Shimming your clutch bell properly is an important part of properly servicing and maintaining your RC.
To much play can cause undue heat and alignment issues resulting in premature bearing failure.
This kit contains 4 shims. 2 Units .1 and 2 units .3
With these units you can mix and match them for the perfect fit. Combinations will get you the following thicknesses.
.1,.2,.3,.4,.5,.6,.7,.8mm Perfect for any clutch system needs.
For use with ALL Losi 5ive clutch bells and clutch systems. Turtle Racing clutch system for the HPI Baja
- (1) 4 shims. 2 Units .1 and 2 units .3
Part #: TFE372
It's hard to write about something as small and easy to use as shims. They are either the advertised size or they are not. Everything is as advertised, including the OD, which was too big for the application I intended. The ID was perfect.
All I had to do was take a dremel and cut down the OD. Once I got it down to approximately 17mm it fit and worked perfectly. Thanks to FastEddy for selling a 15mm shim that no one else does.